Cateye EC-T220 Treadmill User Manual


 
12
MSC Wireless Heart Rate Sensor
TOP
MSC Wireless Heart Rate Sensor
TOP
3
PUTTING ON THE CHEST-BELT HEART RATE SENSOR
Your heart rate can be measured by the chest-belt heart rate sensor.
The EC-T220 treadmill receives and calculates the number of heartbeats which are transmit-
ted from the wireless chest-belt. It is therefore possible to control your heart rate during
exercise. Accurate heartbeat measurement is possible, even for those persons whose pulse is
difficult to detect.
When a heart rate signal is received and calculated, a graph of the heart rate is displayed at
the top of the LCD screen. The pulse itself is also displayed at the top right of the screen.
When the chest-belt is not worn, the graph and pulse displays are not shown.
The HR control training function will not operate if the chest-belt is not worn.
Function of the chest-belt heart rate sensor
The wireless chest-belt heart rate sensor uses a miniaturized and simplified version of the of elec-
trocardiography concept used in hospitals. For an electrocardiogram, multiple electrodes are at-
tached to the body, and the electric potential difference between them is used to calculate the heart
rate. The chest-belt heart rate sensor's two internal electrodes are applied to the body and detect
the electric potential difference, providing a simpler way of detecting heartbeats. This information
is sent to the control unit by radio waves, so even hard training is possible. The chest-belt heart rate
sensor uses the chest-belt (transmitter) and the signal-receiving circuit board (receiver) contained
in the control unit to read your heart rate and calculate and display your per-minute pulse.
Before putting on the chest-belt heart rate sensor
Warning
Pace maker users should never use this device.
Caution: Put on the chest-belt heart rate sensor at the center of your chest and in con-
tact with your skin.
To increase measurement effectiveness, dampen the electrode area with wa-
ter or electrocardiograph electrolyte cream.
People with sensitive skin can put on the chest-belt over a thin shirt with
electrode area damped with water.
Hair on the chest may interfere with accurate measurements.
Putting on the chest-belt heart rate sensor
Put it on following the procedure below.
1. Adjust the length of the attachment belt to fit your chest.
Caution: May be painful if tightened too much.
2. Hook the attachment belt to the electrode belt. Place the electrode
area at the center of your chest. Be sure that the electrode area is held
firmly against your skin.
Reference: When wearing the chest-belt heart rate sensor over a
shirt it is necessary to moisten the electrode area for the
better results. In the winter season when skin can be
dried, errors may occur even when the electrodes are in
direct contact with your skin. This can be improved by
moistening the electrodes.
3. Adjust the belt so that the transmitter is at the center (just above your
diaphragm) of your chest.
Reference: When wearing the chest-belt heart rate sensor over a
shirt it is necessary to moisten the electrode area for the
better results.
The chest-belt heart rate sensor uses a lithium battery.
The lithium battery has a limited lifetime; when chang-
ing the battery, refer to the Reference Guide, page 38,
"Maintenance of the chest-belt heart rate sensor."
Attachment belt
Hook
Electrode belt
Electrode area
Transmitter