Filter
Top Products
STEP 6 – Assemble Swing Arms and
Connecting Arms
a) Remove (1) Allen Bolt, (1) Spacer, (1) Washer and
(1) Nylon Nut from the Left Swing Arm.
b) Position Left Connecting Arm inside “U” Bracket on
Left Swing Arm, see Figure 6, and align bolt holes.
c) Insert the (1) Allen Bolt that was removed in
Step 6a. Slide Spacer over bolt and secure using
(1) Washer and (1) Nylon Nut. Tighten with Multi
Hex Tool provided.
d) Remove (4) Phillips Bolts located in the outside
and inside Left Swing Arm Covers.
e) Position covers over “U” Bracket and Spacer, snap
covers together and secure with the (4) Phillips
Bolts removed in Step 6d.Tighten bolts.
f) Repeat Steps 6a - 6e to assemble right side.
8
STEP 5 – Swing Arm Installation
a) Remove (2) Washers and (1) Nylon Nut from
Left Vertical Column Arm.
b) Slide Left Swing Arm onto Left Vertical Column
Arm with Pulse Sensor Wire to the inside, see
Figure 5.
c) Slide (1) Large Washer onto Left Vertical
Column Arm and screw on (1) Bushing Cap
with open end facing out.
d) Install (1) Washer and (1) Nylon Nut that were
removed in Step 5a and tighten with Multi Hex
Tool provided.
e) Place Snap Cap over end and “snap” into place.
f) Repeat Steps 5a - 5e to install Right Swing Arm.
Figure 5 - Install Swing Arms
Figure 6 - Swing and Connecting Arms Assembly
STEP 7 – Stationary Handlebar Installation
a) Remove (1) Short Allen Bolt, (2) Long Allen Bolts,
(2) Nylon Nuts, (3) Washers and (2) Nut Caps from the
Vertical Column, see Figure 7.
b) Align front bolt hole in Stationary Handlebar with front
bolt hole in Vertical Column. Insert (1) Allen Bolt and
(1) Washer removed in Step 7a and tighten.
c) Re-install (2) Allen Bolts, (2) Nylon Nuts and
(2) Washers that were removed in Step 7a.
Tighten bolts and install (2) Nut Caps.
Figure 7 - Install Stationary Handlebar
M8 washer
M4 x 16mm
allen bolt
(short)
M8 x 57mm
allen bolt
(long)
M8 washer
nut
cap
M8
nylon
nut
stationary
handlebar
vertical column
left swing arm
M10 x 57mm
allen bolt
left swing
arm cover
M4 x 16mm
phillips bolt
left connecting arm
M4 x 16mm
phillips bolt
M10
nylon
nut
M10
washer
spacer
pulse sensor
extension wire
left vertical
column arm
pulse sensor
wire
snap cap
M10
nylon nut
M10 washer
bushing cap
M10 large washer
left swing arm
vertical
column
left swing
arm cover
“U”bracket