Bushnell 950 Elliptical Trainer User Manual


 
the Computer may not be picking up a strong
Heart Beat signal. Change the position of your
hands on the Hand Pulse Sensors. If using the
Chest Strap, add water or conductive gel to the
(2) conductive rubber areas or re-adjust the
position of the strap on your chest.
A horizontal position provides the best reception.
With the Book Holder installed, the Book Holder
slightly interferes with the Receivers horizontal
position, but the position shown below is OK.
Your trainer comes with a Wireless Heart
Rate Chest Strap. Wearing the Chest Strap
during exercise will allow you to have a Heart Rate
reading regardless of hand placement.The receiver
that plugs into the Computer (next to the book
holder) is the Heart Rate Receiver. It must be
plugged into your Computer so it can receive the
wireless signal from the Chest Strap. Follow the
instructions in the Wireless Chest Strap package for
directions on how to use the Wireless Chest Strap
while exercising.
Note: If the Wireless Chest Strap is used and your
units batteries have never been charged or are
low, then the unit must be exercised at minimum
speed of 25 RPM’s to insure an accurate Heart Rate
reading.
Important: To insure good contact and an
accurate Heart Rate readout, the (2) conductive
rubber areas located on the inside of the Chest
Strap must be well-hydrated with water or
conductive gel.
When the Wireless Chest Strap or Hand Pulse
Sensors are used, the Lower Window Display will
show a blinking light that matches your Heart Beat.
If there is no blinking light, or if it blinks irregularly,
12
HEART RATE CHEST STRAP AND RECEIVER
Heart Rate Receiver
Placement Position
receiver
wireless chest
strap