Filter
Top Products
14
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
STEP
Pec Dec Cable (88)
Stamped Eye End
Stamped Eye End
2055 mm 6’ 9”
NOTE:
Leave all pulley bolts hand tight until step 15
A. Bolt Pec Dec Cable (88) to Left Pec Dec Cam (P) as shown in diagram 1 using:
One 50 (3/8” x 1” hex head bolt)
One 71 (3/8” nylon lock nut)
B. See diagram 1. Route Cable (88) through Pulley Swivel (AC) on the left side, hold cable in place
with Pulley (C1) using:
One 51 (3/8” x 1 3/4” hex head bolt)
T
wo 74 (3/8” washer)
One 71 (3/8” nylon lock nut)
C. See diagram 1. Route Cable (88) up and into 90 Degree Double Pulley Holder (CC) and install
Pulley (C2) using:
One 51 (3/8” x 1 3/4” hex head bolt)
T
wo 74 (3/8” washer)
One 71 (3/8” nylon lock nut)
B. Insert Cable (88) thr
ough Pulley Swivel (AC) on the right side, hold cable in place by installing
Pulley (C3) as shown in diagram 2 using:
One 51 (3/8” x 1 3/4” hex head bolt)
T
wo 74 (3/8” washer)
One 71 (3/8” nylon lock nut)
C. Attach Cable (88) to Right Pec Dec Cam (S) as shown in diagram 1 using:
One 50 (3/8” x 1” hex head bolt)
One 71 (3/8” nylon lock nut)
36