Filter
Top Products
8
Be careful to assemble all components
in the sequence they are presented.
24
STEP
mm
Inch
A. Attach Right Leg Hold Down (AG) and Left Leg Hold Down (AH) to the Angled Support Frame (D)
using:
Two 56 (3/8” x 3 1/4” hex head bolt)
Four 78 (3/8” washer)
Two 71 (3/8” nylon lock nut)
Slide two 4”x 8” Foam Rollers (18) onto the two Leg Hold Downs (AG) and (AH). Hold in place
with two
Plastic Roller End Caps (30).
B. Insert two Nylon Bushings (31) into Back Pad Holder (BA).
Attach Back Pad Holder (BA) to Angled Suppor
t Frame (D) using:
Two 53 (3/8” x 3” hex head bolt)
Four 78 (3/8” washer)
T
wo 71 (3/8” nylon lock nut)
C. Slide two Convex End Caps (3) into the top and bottom of Back Pad Frame (BC).
Attach Back Pad (BB) to Back Pad Frame (BC) using:
Two 60 (5/16” x 1 1/2” hex head bolt)*
T
wo 77 (5/16” spring lock washer)
Two 76 (5/16” washer)
*D
o NOT over-tighten these bolts. Tighten these bolts until spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
D. Attach Back Pad Frame (BC) to Back Pad Adjuster (BD) with Pop Pin (65) and using:
One 59 (3/8” x 5/8” allen head bolt)
One 78 (3/8” washer)
E. Slide Convex End Cap (2) into the Back Pad Adjuster (BD).
Slide Back Pad Adjuster (BD) into Back Pad Holder (BA) and hold in place with Pop Pin (63) and
using:
One 66 (5/16” x 1/2” flat allen head bolt)
One 76 (5/16” washer)
NOTE:
Y
ou should now make sure all bolts and nuts are
wr
ench tight.
Do NOT re-tighten any of the pad bolts.
Also, leave all pulley bolts finger-tight untill after STEP 15.