Filter
Top Products
Page 57
3. 4600 PT/CL: Use the fastener removal tool to release the cover
fasteners and separate the top covers.
4. To reinstall the 4400 PT/CL and 4200 PT fasteners, remove the pin
completely from the base. Insert the base into the hole in the covers.
Insert the pin into the base until it is flush with the base.
Shield (4600 PT/CL )
1. Remove the two mounting
screws from the bottom shield.
2. Separate the top shield from the
bottom shield and remove the
upper and lower shield from the
handrail.
Bottom Cover
1. Remove the mid cover.
2. 4600/4200/4400 PT: Disconnect the DC power cable from the
connector located on the bottom side of the left bottom cover.
3. Remove the fastener located on each side of the lower edge of
the bottom cover (see Figure 24).
4. 4400/PT/CL, 4200 PT: Kneel in front of the machine, facing the cover
seam. Push in and hold both sides of the lower cover to disengage
the locking tabs at the joint between the upper and lower covers. Use
your hands to push up the top cover and separate the top cover from
the bottom cover. Pull out and forward on the lower cover to remove it
from the frame.
4600 PT/CL: Remove the cover fasteners and separate the left and
right top cover from each other. Pull out and forward on the lower
cover to remove it from the frame.
PARTS REMOVAL AND REPLACEMENT