Filter
Top Products
Page 7
4. If you have a 4600/4400 CL, skip to step 9. If you have a 4600/4400/
4200 PT, connect the DC cable of the power supply to the connector
near the bottom of the left side cover (see Figure 4).
Figure 4: DC Power Connector
5. Place the power supply on the floor near an AC wall outlet. To reduce
the hazard of electrical shock, place the power supply in a location
away from the machine and away from exposure to perspiration. You
should not place your power supply on a carpet because it may over
heat.
INSTALLATION INSTRUCTIONS