Filter
Top Products
Page 8
6. Check to be sure that the input AC power rating marked on the power
supply matches the available power. If it does not, obtain the match-
ing power supply from StairMaster
®
Health & Fitness Products, Inc.
before proceeding any further.
7. Connect the AC power cord to the AC wall outlet. Refer to the
“Grounding Instructions” section if the AC wall outlet does not
accept athree-prong plug.
8. Watch the console. The 4600/4400 PT should display a software
revision code and then show “SELECT WORKOUT.” The 4200 PT
console should run through a self test and then display a moving line
in the upper LCD window. If the console does not, unplug the power
supply and then plug it back in. If the console still does not power up
correctly, contact our Customer Service Department. Refer to the
Appendix for the appropriate phone number.
9. If you have a 4600/4400 CL, step on the pedals to check for proper
operation. Once you step on the pedals, the console should display a
software revision code and then show “SELECT WORKOUT.” If it
does not, connect the battery charger to the connector on the lower
left side. If the console still does not power up contact our Customer
Service Department. Refer to the Appendix for the appropriate phone
number.
10. The display “SELECT WORKOUT” tells you the machine is ready to
use. The 4600/4400 PT/CL console displays this message and the
4200 PT displays a moving line in the upper LCD window when the
console is ready to use.
INSTALLATION INSTRUCTIONS
TO REDUCE THE RISK OF ELECTRICAL SHOCK AND FIRE AND TO
PREVENT SEVERE DAMAGE TO THE MACHINE, USE ONLY THE POWER SUPPLY
APPROVED FOR USE WITH THIS EQUIPMENT. IN ADDITION,
YOUR MACHINE MUST BE PROPERLY GROUNDED.
!
WARNING