Filter
Top Products
14. Attach the Seat (28) to the Upright (9} with the two
1/4" x 3/4" Bolts (20) and a 1/4" x 2 1/2" Bolt
(46).
15. Center one Pad Tube (22) in the Upright (9), and the
other Pad Tube in the Leg Developer (23). Slide the
four Small Pods (17) onto the ends of the Pad Tubes.
16. Restthe Leftand Right Pedals (75, 76) on the hooks
at the lower ends of the Resistance Cylinders (84).
Make sure that the hooks are fully inserted into the
same slotsunder both Pedals.
Plug the TransFormer (39) intothe jack located near
the bottom of the Right Side Shield (12).
17. Make surethat oil ports are properly tightened. Theuse of oil remaining PoX will be explained in ADJUSTING
THE CROSSTRAINER e, beginning on page 8 oFthis owner's manual.
18. Before using the CROSS TRAINER e, test the cables and thepulleys. Make sure that the cables are in the grooves
in the pulleys. If the cables do not move smoothlyover the pulleys, locate and correct the problem before using
the CROSSTRAINERe. If the'€':ablesare not properly routed, they will be damaged when used.
7