Filter
Top Products
_°
AI"T._,CHING THE I-AT BAR, ROWER BAR OR
STRAPTO THE LOW PULLEY STATION
Attach the Lot Bar {36} to the Main Cab}e (51) with a
Cable Clip (33). For some exercises, the Chain (38}
should be attached betweenthe LOtBar and the
Maln Cable wlth two Cable Clips. Adjust the length
of the Chain between the Lot Bar and the Main
Cable so the Lot Bar is in the correctstarting posi-
tion for the exercise to be performed.
The Rawer Bar (34} or the Strop (35) can be
altached in the same manner.
34
38
33
TROUBLE-SHOOTING AND MAINTENANCE
Inspect and tighten all parts each timeyou use the CROSSTRAINER e. Replaceany worn ports immediately. Outside
surfaces of the CROSSTRAINER e can be cleaned using a damp clothand mild detergent. Keep all liquids away Earn
the stepper console and the PERSONALTRAINERcomputer.
Most CROSSTRAINERe problems canbe salved by follow;ng the steps below. F_ndthe applicable symptom and follow
the step(s) listed. If further ossis_nce isneeded, coil our Customer Service Department toil-free at 1-800-999-3756,
Monday through Friday, 6.a.m. until 6 p.m. Mountain .time (excludlng holldays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the transformer is fullyplugged into the jack on theCROSS TRAINERe, and into a 120-volt ou_et.
2. SYMPTOM" THE MAIN CABLE DOES NOT MOVE SMOOTHLY, OR THERE IS SLACK IN THE MAIN CABLE
a. Inspectthe routing of thecables and make sure that they are in the grooves in all of the pulleys. If they are not,
correct the problem. If the cables are not properly routed, they will be damaged when used.
b, If there isslack in the Main Cable (51}, locate the
AdjustmentBracket (53) near the bottom of the
right sideshleld.Hold theend of theWeight
Cable (52) Firmly, and s}ide theAdjustment
Bracket farther onto the Weight Cable..tighten
the 5/16" Nut (821 against theAdjustment
Bracket. Testthe Main Cable. IFthe motor stalls
or hesitates, loosen the 5/16" Nut slightly, ffthe
5/16" Nut is tightened as Faras Passib}e and
there is still slack, the Mo;n Cable should be
replaced. See ORDERING REPLACEMENTPARTS
on the back cover oFth_sowner's manual.
13
\
53 52
51
9