Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not dis-
pose of the packing materials until assembly is completed. Assembly requires the included allen wrench .
1. See the inset drawing. Remove the Base Extensions (76)
from the packing materials.
Refer to the drawing on page 6 and identify the right
side of the treadmill. With the help of a second person,
carefully lay the treadmill on its right side; do not lay the
treadmill on its left side or the storage latch may be
damaged.
Firmly slide a Base Extension (76) into one side of the
Base (86). Using the Allen Wrench (89), tighten an
Extension Bolt (13) into the Base Extension and the Base.
Attach the other Base Extension (not shown) in the same
manner.
2. Attach six Base Pads (43) to the Base (86) and the Base
Extensions (76) in the indicated locations. Note: One extra
Base Pad may be included.
With the help of a second person, carefully raise the
treadmill to the upright position so the Base (86) and the
Base Extensions (76) are resting on the floor.
3. Locate the two shipping brackets on the back of the tele-
vision. Remove the four indicated screws. Discard the
four screws and the shipping brackets.
76
76
Packing Materials
13
89
86
1
86
86
76
76
43
2
Shipping
Brackets
Screws
3
7