Filter
Top Products
22
To turn the CCD on or off, press the CCD ON button.
When the CCD is on, the TV screen will appear as
shown below.
1. With CCD broadcast
2. Without CCD broadcast
caption mode on, text off
3. Push CCD buttons, CCD
Note: In the cases shown
above, the display is for
CCD caption mode on, text
mode off.
Selecting the Data Channel
When the CCD function is on, the data channel is se-
lected by pressing the CCDÐ1, 2 button. The CCD func-
tion status will be displayed for four seconds.
Using the Text Display Function
The text function can be toggled on or off by pressing
the CCD TEXT button. When the text function is on but
no text data is received, the TV screen will appear as
shown in drawing 2 above. The data channel can be
selected while in the text mode, just as when in the cap-
tion mode.
Note: The closed-caption text will cover the exercise
information at the bottom of the TV screen. If desired,
the position of the exercise information can be changed
to the top of the TV screen. See HOW TO SELECT
THE INFORMATION MODE on page 15; refer to the
paragraph at the bottom of the page.
When the menu is used, pressing the MENU button will
display a menu that allows selection of channel mem-
ory, the clock, the on timer, the off timer, or picture level
controls. When the MENU button is pressed, the display
will be as shown below.
TV Mode Video Mode
Follow the steps below to connect your VCR (not in-
cluded) to the treadmill. A CATV cable (75 ohm coaxial
cable) is required.
1. Connect one end of the CATV cable to the video out-
put jack on the VCR.
2. Plug in the power cord of the VCR. Refer to your
VCR userÕs manual for proper grounding instructions.
3. Connect the CATV cable to the 75 ohm antenna ter-
minal on the treadmill. (See assembly drawing 6 on
page 8 for the location of the terminal.)
To operate the VCR with the
TV, make sure that the on/off
switch located on the front of
the motor hood is in the ÒonÓ
position, and that the power
cord is properly plugged in
(see page 9).
To turn on the TV, press the POWER button on the TV or
the remote control. Make sure that the TV is on channel 3
or 4. Note: When the treadmill is not in use, you may
want to leave the surge protector plugged in. Each time
the power cord is unplugged, the TV must go through an
automatic channel resetting routine when the power is
turned on again.
IMPORTANT: For the console and television to oper-
ate properly, the VCR must be turned on, a videocas-
sette must be properly inserted, and the VCR must
be playing. Refer to your VCR userÕs manual for op-
erating instructions.
HOW TO CONNECT A VCR
USING THE CLOSED CAPTION DECODER (CCD) USING THE MENU FUNCTION
A B C . . . . . . . . . .
. . . . . . . . . . X Y Z
No Caption
CCD On
Ch 1
Text Off
CH MEMORY
ANALOG
CLOCK/TIMER
ANALOG
CLOCK/TIMER
OFF
ON
ÒOnÓ
Position