ProForm 785 TL Treadmill User Manual


 
To set the TV to turn off
after a preset amount of
time, press the SLEEP but-
ton on the remote control.
Each time the button is
pressed, the clock will count
down by 10 minutes: 120,
110, 100, . . . 20, 10, 0.
To cancel the sleep timer, press the SLEEP button re-
peatedly until the clock counts down to 0.
Your TV has the capability to turn on, switch to a chan-
nel for recording, and then turn off againÑall automati-
cally. Follow the instructions below to use this feature.
Note: When setting the clock, the on timer, or the off
timer, if no buttons are pressed for four seconds, the TV
will return to the normal screen.
Setting the Clock
1. Press the TIMER button
to turn on the setting
menu.
2. Press the + or Ð button to set the clock to the correct
time.
Setting the On Timer
1. After the clock has been
set, press the TIMER but-
ton repeatedly to select
ON TIME.
2. Press the + or Ð button to set the time that you want
the TV to turn on.
Setting the Channel to be Recorded
1. After the on timer has
been set, press the
TIMER button repeatedly
to select ON CH (on
channel).
2. Press the + button to cycle through the channels until
the desired channel is selected.
3. Press the Ð button to cycle through the four channel
modes: (1) TV, (2) STD, (3) HRC, (4) IRC.
After the channel has been set, press the TIMER button
repeatedly to select the on/off setting mode of the on
timer. Pressing the + or Ð button at this point will
change the display to ÒON,Ó reset the seconds of the on
timer, and start the count.
Setting the Off Timer
1. After a channel has been
set, press the TIMER
button repeatedly to se-
lect OFF TIME.
2. Press the + or Ð button to set the time that you want
the TV to turn off.
After the channel has been set, pressing the TIMER
button will select the on/off setting mode of the off timer.
Pressing the + or Ð button at this point will change the
display to ÒON,Ó reset the seconds of the off timer, and
start the count.
Pressing the DISPLAY button on the remote control
makes it possible to display either the channel number
or the AV mode and time. Displays activated by the
DISPLAY button remain until the DISPLAY button is
pressed a second time, or until the power is turned off.
Note: If the closed caption decoder is active, the display
of the channel number and time will appear on the
screen for only three seconds.
USING THE SLEEP TIMER
USING THE RECORDING TIMER
VIEWING THE CHANNEL NUMBER AND TIME
SLEEP 120
CLOCK AM 12:00
ON TIME
AM 12:00 OFF
ON CH 02 TV
OFF TIME
AM 12:00 OFF
CLOCK AM 12:00
ON TIME
AM 12:00 OFF
ON CH 02 TV
OFF TIME
AM 12:00 OFF
CLOCK AM 12:00
ON TIME
AM 12:00 OFF
ON CH 02 TV
OFF TIME
AM 12:00 OFF
CLOCK AM 12:00
ON TIME
AM 12:00 OFF
ON CH 02 TV
OFF TIME
AM 12:00 OFF
21