Filter
Top Products
Turning on the Power
To turn on the TV, press the POWER button on the TV
or the remote control.
Volume Control
To adjust the volume to the desired level, press the
VOLUME + or Ð button.
The sound level will be
shown by a bar on the TV
screen. As the sound level
is increased, the bar will
move to the right. As the
sound level is decreased,
the bar will move to the left.
Note: If no broadcasting
signal is received, the sound will be muted and the vol-
ume control will be disabled.
Direct Channel Selection (by Remote Control)
Use the channel selection
buttons on the remote con-
trol to select a channel
number. The channel num-
ber will appear on the upper
right corner of the TV
screen. For channels 2
through 9, press the 0 but-
ton and then press the de-
sired channel number (if the
0 button is not pressed first,
channel selection will be
delayed for 3 seconds). For channels 10 through 99,
press the two digits in order. Be sure to press the sec-
ond digit within 3 seconds after pressing the first. For
CATV channels over 100, press the 1-- button first and
then press the desired channel numbers.
Skip Mode
Press the CHANNEL Æ or button to select memo-
rized channels, skipping over empty channels. Hold
down the CHANNEL Æ or button to change channels
continuously. Note: If no channels are memorized, the
TV will switch to the SEARCH mode.
Search Mode
Press the CHANNEL Æ or button to search for the
next available channel. Hold down the CHANNEL Æ or
button to search through all available channels.
Note: Before selecting channels with the CHANNEL Æ
or button, the channels must be set into the TVÕs
memory. See MEMORIZING CHANNELS at the right.
Memorizing Channels
The TV is equipped with a channel memorizing function
that allows you to step up or down from the current
channel to the next channel set into memory. Before
channels can be selected in this way, they must be set
into the TVÕs memory. Note: When programming chan-
nels, if no buttons are pressed for four seconds, the TV
will return to the normal screen.
Automatic Memory Tuning
1. Press the MENU button to
turn on the pop up menu in
the TV mode or CATV
mode. Press the MENU
button again to select CH
MEMORY (channel mem-
ory).
2. Press the MENU button
again to select AUTO
MEMORY.
3. Press the + button to start
AUTO MEMORY. The TV
will begin setting into
memory all the channels
available in your area.
When no broadcast signal
is detected on a channel,
the channel is erased from
memory. When a signal is detected, the channel is
stored in memory and the next channel is selected.
This process will be re-
peated until the highest
channel is reached. It then
stops at the lowest channel
stored in memory, and re-
turns to a normal screen
after four seconds. The TV
will then be in the SKIP
mode.
Æ
Æ
Æ
Æ
Æ
CHANNEL PROGRAMMING
CH MEMORY
ANALOG
CLOCK/TIMER
TV 07
AUTO MEMORY
START [+]
TV 07
AUTO MEMORY
END
AUTO MEMORY
SEARCH/SKIP
MEMORY ADD
¥ERASE
TV/CATV
VOLUME
18