Filter
Top Products
536i Elliptical Fitness CrossTrainer Assembly Guide 5
Assembly Steps
Remove the packaging around the ramp support covers.
Grasp the magazine rack at its base and slide it up and off the
front ramp support cover. Set it aside.
Use a long-handle ⁵⁄₃₂-inch hex key to remove the four
fasteners that secure the front ramp support cover. Set the
fasteners aside.
A tab on each side of the front ramp support cover holds the
front and back covers together. Gently squeeze the sides of
the back covers to release the tabs. Remove the front ramp
support cover.
While holding the foam pouch in place, ask your assistant to
lift and hold the ramp while you position the lift motor
assembly and slide the yoke into the ramp.
Note: The foam pouch has been placed over the end of the
ramp to avoid scratches to the cover. The pouch will be
removed once the stabilizers are attached and secure.
Secure the base of the ramp support assembly using two hex
head screws (A), two split washers (E), and two washers (B).
Finger tighten.
Secure the ramp to the yoke using two buttonhead
screws (C), two washers (D) and two locknuts (G).
Wrench tighten using the ⁷⁄₃₂-inch hex key and a ⁹⁄₁₆-inch
socket wrench.
Return to the base of the ramp support assembly and wrench
tighten the two fasteners using a ½-inch socket wrench.