Filter
Top Products
536i Elliptical Fitness CrossTrainer Assembly Guide 10
Connect the heart rate cable to the 4-prong receptacle on the
electronics board.
Connect the RJ45 cable to its receptacle on the back of the
display console. An audible click is heard when the cable is
properly attached. Place excess cable inside the console
bracket.
Important: When connecting the RJ45 cable to the back of
the display, look for the receptacle that is in the same
orientation as shown in the illustration below. Text embossed
on the plastic states LOWER BOARD CONNECTION.
Secure the display console with four buttonhead screws (L).
Wrench tighten.
Wrench tighten the hex head screws. Start at the base of the
stabilizers and tighten all eight screws using a ½-inch socket
with an extension. Return to the console bracket. Wrench
tighten the four side screws, and then the two bottom screws.
Lower board
cable
Heart rate cable