Filter
Top Products
536i Elliptical Fitness CrossTrainer Assembly Guide 8
Prepare the stabilizers for installation. Insert a clamp (O)
into each stabilizer and secure it loosely with a buttonhead
screw (L).
Thread a leveler (K) onto each stabilizer.
Note: Make sure the nut is fully threaded onto the leveler.
Refer to the illustration.
For easier access to the base mounts, lift the front of the EFX
off the floor and place a wedge of packaging beneath its
base.
Ask your assistant to hold the stabilizer, which has the cable
protruding from both ends, next to the moving arm assembly
and base frame. While your assistant places the stabilizer on
the pivot tube and wrench tightens the clamp, you can
connect the base cable. An audible click is heard when the
cable is properly attached. Insert the cable into its receptacle
and place excess cable into the base frame.
Secure the stabilizer to the base frame using four hex head
screws (A), four split washers (E) and four washers (B).
Finger tighten.
Note: The split washers should be sandwiched between the
head of the screw and the flat washers. Also, if you encounter
difficulty aligning the base mounts, check the height of the
levelers and adjust them accordingly.
Attach the opposite stabilizer to the metal shaft and wrench
tighten the clamp. Secure the stabilizer to the base frame
using four hex head screws (A), four split washers (E), and
four washers (B). Finger tighten.