Filter
Top Products
C846i/C842i Upright Cycle Assembly Guide 1
Thank you for choosing Precor. For proper installation, please read this guide
thoroughly and follow the assembly instructions. If you do not assemble the
C846i/C842i Upright Cycle according to these guidelines, you could void the
Precor Limited Warranty.
Obtaining Service
You should not attempt to service the cycle except for maintenance tasks as
described in the Product Owner’s Manual. If any items are missing, contact
your dealer. Should you need more information regarding customer support
numbers or a list of Precor authorized service centers, visit the Precor website
at www.precor.com/contact.
Unpacking the Equipment
The unit is shipped on one pallet. Ask for help from two or more people to
unpack and assemble the cycle.
Required Tools
• Wire tie cutter
• One
³⁄₄-inch combination wrench (box-end or crescent)
Installation Requirements
Follow these installation requirements when assembling the unit:
• Assemble the unit near the location where you plan to use it.
• Provide ample space around the unit.
Open space around the unit allows for easier access.
• Set up the cycle on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level. A level unit has
fewer malfunctions.
• Open the box and assemble the components in the sequence
presented in this guide.
• Leave room for adjustments.
Tighten fasteners (bolts, nuts, and screws) so the unit is stable, but
leave room for adjustments. Do not fully tighten fasteners until instructed
to do so.
• If you plan to move the unit, obtain help and use a hand truck. Do not
grasp any plastic parts while lifting or moving the unit. The plastic
parts are not capable of supporting the weight of the unit and they
may break.