Filter
Top Products
Owner’s Manual: Maintenance 31
Periodically, clean the running belt using a soft nylon scrub
brush. Frequently vacuum the floor underneath the unit to
prevent the accumulation of dust and dirt, which can affect
the smooth operation of the unit.
Storing the Chest Strap
Store the chest strap where dust and dirt cannot
accumulate on it, such as a closet or drawer. Be sure to
keep the chest strap protected from extremes in
temperature. Do not store it in an area that may be
exposed to temperatures below 32° F (0° C).
To clean the chest strap, use a sponge or soft cloth
dampened in mild soap and water. Dry the surface
thoroughly with a clean towel.
Checking the Alignment of
the Running Belt
Proper belt alignment allows the belt to remain centered
for smooth operation. Realigning the belt takes a few
simple adjustments. If you are unsure about this procedure,
call Precor Customer Support. Refer to Obtaining Service.
CAUTION: Special care must be taken when aligning
the running belt. Turn OFF the treadmill while adjusting
or working near the rear roller. Remove any loose
clothing and tie back your hair. Be very careful to keep
your fingers and any other object clear of the belt and
rollers, especially in front of the roller and behind the
deck. The treadmill will not stop immediately if an
object becomes caught in the belt or rollers.
1. The treadmill has adjustable rear feet. Make sure that
the running surface is level. If the treadmill is placed on
an uneven surface, adjusting the rear feet can help, but
will not compensate for extremely uneven surfaces.
2. Turn the unit ON.
Note: The treadmill will not operate unless the red
magnet is appropriately placed on the display console.
3. Stand beside the treadmill and press QUICKSTART.
The running belt starts automatically after a 3-second
countdown appears on the display.
4. Press the SPEED ▲ key until the display shows a
speed of 3 mph (5 kph).
CAUTION: If you hear any chafing or the running belt
appears to be getting damaged, stop the running
belt immediately by pressing the STOP key. Contact
Precor Customer Support.
UGuide_A4.book Page 31 Wednesday, February 27, 2008 3:36 PM