Filter
Top Products
Owner’s Manual: Advanced Programming and Troubleshooting 26
4. Press ENTER to accept the displayed setting.
the change will be retained in memory even if the
treadmill is turned OFF and unplugged.
5. If you want to exit without saving the change, press
STOP.
Informational Displays
The treadmill provides information about its use (odometer
and hour meter), as well as model and software version. In
general, you would only access this information if directed
to do so by Precor Customer Support.
These instructions guide you through the informational
displays. Pressing the ENTER/SELECT key moves you
through the displays. To exit, press the HOLD TO RESET key
at any time.
Viewing the Odometer
1. Turn the treadmill OFF and ON.
2. Within two seconds, press the following keys in
sequence and without pause:
STOP, INCLINE ▼, SPEED ▲
Note: If the keys are not pressed within the 2-second
window, the banner returns and you must begin again.
MILE appears in the center display. The odometer value
(the cumulative miles users have traveled) appears in
the DISTANCE/CALORIES and TIME displays. The
furthest digit on the left marks the hundred-thousandths
position, while the furthest digit to the right indicates
tenths of a mile. Refer to Diagram 9.
Diagram 9: Understanding odometer display
3. When you are ready, press ENTER/SELECT to move to
the next display (HOUR).
043.8
MILE
TIME
DISTANCE
CALORIES
000
Thousands of miles
Hundred Thousands of miles
Tenths of a mile
Tens of miles
UGuide_A4.book Page 26 Wednesday, February 27, 2008 3:36 PM