Filter
Top Products
28
l Running
l Cycling
l Swimming
l Other outdoor
l Other indoor
l Triathlon
l Free multisport
If you have edited your sport profiles in the Flow web service before your first training session,and synced
them to your V800, the sport profile list will contain the edited sport profiles.
SETTINGS
To view or modify sport profile settings, go to Settings > Sport profiles and choose the profile you want to
edit. You can also access sport profile settings from pre-training mode by pressing and holding LIGHT. In
sport profiles, that include multiple sports (e.g. triathlon and biathlon) the settings for each sport can be
modified. For example, in triathlon you can modify the settings for swimming, cycling and running.
l Training sounds: Choose Off, Soft, Loud or Very loud.
l Vibration feedback: Choose On or Off. When set on, V800 vibrates, for example, when you start or
stop a training session, GPS signal is found or you reach a training target.
l Heart rate settings: Heart rate view: Choose Beats per minute (bpm), % of maximum or % of Hr
reserve. Check HR zone limits: Check the limits for each heart rate zone. HR visible to other
device: Choose On or Off. If you choose On, other compatible devices (e.g. gym equipment) can
detect your heart rate.
l Bike power settings: Choose Power view, Power, rolling average, Set FTP value or Check
power zone limits. Set how you want to view your power, how frequently data points of your power
are recorded, set your FTP value or view your power zone limits.
Bike power settings are visible only if Kéo Power has been paired.
l GPS recording: Choose Off, Normal or Power save, long session.
l Sport specific tap sensitivity: Choose Off, Light tap, Normal tap, Strong tap or Very strong tap.
Set how hard you have to tap the display when using tap gestures.
l Stride sensor: Choose Calibration or Choose sensor for speed. In Calibration, choose Auto-
matic or Manual. In Choose sensor for speed, set the source for speed data: Stride sensor or GPS.
For more information on Stride sensor calibration, See "Polar Stride Sensor Bluetooth® Smart" on page
86
Stride sensor is visible only if a stride sensor has been paired.