Filter
Top Products
B 34
Swap Time 1 or Time 2
In the Time of Day display press and hold the down button. Time 1 or Time
2 is displayed in the uppermost row for a couple of seconds. Displayed time
will now be used in all watch and alarm functions. If you chose time 2, “2”
is displayed in the Time of Day display.
Shortcut to Watch Setting Loop
Press and hold the signal/light button for a few of seconds to enter into the
watch setting loop. If you want to skip some parts and go directly to a
watch function, scroll up or down until the desired watch function is
displayed. Set the function as in the “Watch settings” section.
Swap Measuring Units as you set your user information on weight and
height. Press and hold the signal/light button until the units are swapped.
Release the button.
Swap Date, User ID Number, User Name and Logo
You are able to set a user ID number, user name and logo by Polar Precision
Performance software. These settings are shown on the upper row of the
Time of Day display. You can swap between the user ID, user name, logo
and date by pressing and holding the up button.
You can upload 7 reminders, each including time and name, to your wrist
receiver from Polar Precision Performance software.
The reminder sounds an alarm only when time of day is displayed. When
the reminder alarm comes on, it will sound for 15 seconds or you can turn it
off by pressing any of the buttons except the signal/light button. Erase the
reminder text by pressing any of the buttons except the signal/light button.
To continue your settings, press the stop button. To return to the Time of
Day display, press and hold the stop button.
Setting Tips