Filter
Top Products
8
4. Thread two Upright Bolts (106) into each Upright (96,
107) in the indicated locations. Do not tighten the
U
pright Bolts yet.
107
106
106
96
4
5. Next it will be necessary to adjust the incline of the
INCLINE TRAINER. First, plug in the power cord (see
page 10). Next, make sure that the on/off circuit breaker
is in the on position (see step 2 on page 14).
Place the Key (90) in the Console (89). Press the
QUICK INCLINE button labeled “21” to adjust the in-
cline to 21%. Then, remove the Key.
Move the on/off circuit breaker to the off position
and unplug the power cord.
6. Thread two additional Upright Bolts (106) into each
Upright (96, 107) in the indicated locations. Tighten all
eight Upright Bolts in the Uprights.
7. See step 2 on page 7 and tighten the four Handrail
Bolts (93).
Place the Upright Caps (92) over the Handrail (94) and
the upper ends of the Uprights (96, 107). Press the
Handrail Caps against the hook-and-loop fastener strips
on the Uprights. Attach each Handrail Cap with four
Upright Cap Screws (91).
Do not overtighten the
Upright Cap Screws.
90
89
QUICK INCLINE
buttons
107
106
106
106
92
94
91
91
96
107
91
91
96
92
5
6
7