Filter
Top Products
20
Each pulse-driven program is divided into one-
minute segments. (The main display will show both
t
he time remaining in the program and the time re-
maining in the current segment of the program.)
O
ne target heart rate setting is programmed for
each segment. (During the MANUAL PULSE pro-
gram, the same target heart rate setting will be
programmed for all segments.)
When only three seconds remain in the first seg-
ment of the program, a series of tones will sound
and the speed and/or incline of the INCLINE
TRAINER will change, if needed, to bring your
heart rate closer to the target heart rate setting for
the next segment. The speed and/or incline setting
will flash in the main display to alert you before the
speed and/or incline changes. The program will
continue until no time remains in the program. The
walking belt will then slow to a stop.
If the speed or incline setting for the current seg-
ment is too high or too low, you can adjust the set-
ting with the SPEED or INCLINE buttons.
However, if you
decrease
the speed, the incline
will automatically
increase
; if you
increase
the
speed, the incline will
decrease
. If you
increase
the incline, the speed will
decrease
; if you
de-
crease
the incline, the speed will
increase
.
The
INCLINE TRAINER will always attempt to keep
your heart rate near the target heart rate setting
for the current segment.
Note: When the incline
reaches the lowest setting, the speed cannot be
increased any further. When the incline reaches
the highest setting, the speed cannot be de-
creased any further.
If your pulse is not detected during the program,
the letters PLS will flash in the main display and
the incline and speed of the INCLINE TRAINER
may automatically decrease until your pulse is de
-
tected. If this occurs, see the instructions included
with your chest pulse sensor.
To stop the program at any time, press the STOP
button. Pulse-driven programs should not be
stopped temporarily and then restarted. To use a
pulse
-driven program again, reselect the program
and start it at the beginning.
Follow your progress with the main display.
See step 5 on page 15.
When the program is completed, remove the
key.
See step 6 on page 18.
H
OW TO USE THE FITNESS TEST PROGRAM
The fitness test program measures your relative fitness
l
evel. For the best results, the program should be used
a
t a time when your energy level is high; the program
should not be used if you have already exercised dur-
ing the day. Follow the steps below to use the program.
Put on a Polar
®
-compatible chest pulse sensor
(not included).
You must wear a chest pulse sensor to use the
fitness test program.
See the instructions in-
cluded with your chest pulse sensor.
Insert the key into the console.
See GETTING STARTED on page 14.
Select the fitness test program.
When the key is inserted, the manual mode will be
selected. To select the fitness test program, press
the PROGRAM SELECT button repeatedly until
the words FITNESS TEST appear in the main dis-
play.
When the fitness test program is selected, the
words FITNESS TEST will scroll across the main
display. The words ENTER AGE and the current
age setting will then be shown.
During fitness test
program, the matrix
will show a moving
graphic that repre
-
sents your heart rate.
Each time a heart-
beat is detected, an
additional peak will appear in the graphic.
Enter your age.
You must enter your age to use the fitness test
program.
To enter your age, see step 4 on page
19.
4
3
2
1
8
7