Filter
Top Products
27
Regular maintenance is necessary for the optimal performance and long life of the INCLINE TRAINER.
P
lease read and follow all instructions below. If the INCLINE TRAINER is not maintained as described,
components may wear excessively and the INCLINE TRAINER may be damaged. If you have questions about
maintenance, please contact your distributor. CAUTION: Make sure to remove the key and unplug the power
cord before performing any maintenance procedures.
WEEKLY MAINTENANCE
1. Unplug the power cord. Inspect and properly tighten all external parts of the INCLINE TRAINER.
2. Apply a mild multi-purpose cleaner to a 100% cotton cloth and remove any dust and grime from the handrails,
uprights, foot rails, frame, and motor hood. In addition, wipe the walking platform along the sides of the walk-
ing belt.
Do not wipe under the walking belt. Apply a small amount of mild multi-purpose cleaner to a 100%
cotton cloth and wipe the console and the screens.
Do not spray cleaner directly onto the INCLINE
TRAINER or use ammonia or acid-based cleaners.
3. Make sure that the walking belt is centred and properly tightened. If it is centred and runs smoothly, do not
make any adjustments. If the walking belt needs to be adjusted, see pages 33 and 34.
MONTHLY MAINTENANCE
1. Unplug the power cord. Remove the screws attaching the
motor hood and lift off the motor hood. Using a hand-held
vacuum, clean the area under the electronics cover. Be care-
ful to avoid touching any components.
2. Plug in the power cord and insert the key into the console.
Raise the INCLINE TRAINER to the highest incline level.
Remove the key and unplug the power cord. Check the
motor belt for wear and cracks. If the motor belt needs to be re-
placed, see page 44 to order a new motor belt.
3. Plug in the power cord and insert the key into the console. Press the START button. Be careful to avoid in-
jury; keep your hands away from moving parts and make sure that your clothing cannot become
caught in moving parts. Whilst the walking belt is moving, check the motor for arcing. Next, check the IN-
CLINE TRAINER for unusual noises or odors. If any of these problems exists, contact your distributor.
Remove the key and unplug the power cord. Reattach the motor hood with the screws.
4. The walking platform should not be lubricated before the
INCLINE TRAINER is used. However, lubricant should be
applied at least once every month. To purchase a lubricant
pump or lubricant packets, please contact your distributor.
Use only FreeMotion Fitness lubricant. Using other lubri
-
cants may damage the walking belt and will void the war-
ranty. CAUTION: Before applying lubricant, remove the
key and unplug the power cord.
To use lubricant packets, open one packet, reach under one
side of the walking belt as far as you can, and apply the entire
packet between dotted line A and dotted line B. Then, apply a
second packet under the opposite side of the walking belt in
the same way.
After you have applied lubricant, plug in
the power cord, insert the key, adjust the speed to 3 mph,
and walk on the walking belt for two minutes to spread the lubricant.
PREVENTIVE MAINTENANCE
Apply
packet
here
Motor
Belt
Electronics Cover
A
B