Filter
Top Products
32
4. SYMPTOM: THE WALKING BELT IS OFF-CENTRE OR SLIPS WHEN WALKED ON
a
.
I
f the walking belt has shifted to the left: Remove the
key and unplug the power cord. Using the included hex
k
ey, turn the roller adjustment bolts in the directions
shown, 1/4 of a turn each. Be careful not to overtighten the
walking belt. Plug in the power cord, insert the key and
use the INCLINE TRAINER for a few minutes. Repeat until
the walking belt is centred.
b.
If the walking belt has shifted to the right: Remove the
key and unplug the power cord. Using the included hex
key, turn the roller adjustment bolts in the directions
shown, 1/4 of a turn each. Be careful not to overtighten the
walking belt. Plug in the power cord, insert the key and
use the INCLINE TRAINER for a few minutes. Repeat until
the walking belt is centred.
c.
If the walking belt slips when walked on: Remove the
key and unplug the power cord. Using the included hex
key, turn both roller adjustment bolts clockwise 1/4 of a
turn. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 2.5 to 5
cm (1 to 2 in.) off the walking platform. The centre of the
walking belt should just touch the walking platform. Make
sure to keep the walking belt centred. Plug in the power
cord, insert the key and run the INCLINE TRAINER for a
few minutes. Repeat until the walking belt is properly tight-
ened. Note: As you tighten the roller adjustment bolts, the
front roller will move. If the front roller stops moving, do
not further tighten the roller adjustment bolts; contact
your distributor.
5. SYMPTOM: THE WALKING BELT STOPS OR THE INCLINE CANNOT BE ADJUSTED EVEN THOUGH
THE CONSOLE REMAINS LIT
a. This indicates that a controller error may have occurred. To correct the problem, see step 8 on page 22.
6. SYMPTOM: THE INCLINE SYSTEM DOES NOT FUNCTION PROPERLY OR THE INCLINE SYSTEM DOES
NOT APPEAR TO BE AT THE INCLINE LEVEL SHOWN IN THE MAIN DISPLAY
a. The incline system may need to be calibrated. To initiate the calibration routine, hold down the SPEED +
button and the SPEED –
button simultaneously for three seconds. During the calibration routine, the INCLINE
TRAINER will automatically travel to the lowest incline setting and then return to level.
b. If the incline system still does not function properly, contact your distributor.
7. SYMPTOM: THE WORDS LUBRICATE DECK APPEAR EVERY FEW MINUTES IN THE MAIN DISPLAY
a. If the words LUBRICATE DECK appear in the main display, the walking platform should be checked for ade-
quate lubricant. Follow the instructions in step 4 on page 27 to lubricate the walking platform if necessary.
After you have lubricated the walking platform, see HOW TO RESET THE LUBE REMINDER on page 24.
If
this is not done, the words LUBRICATE DECK will continue to appear.
a
b
c