Filter
Top Products
22
H
OW TO USE THE MAINTENANCE MODE
The console features a maintenance mode that allows
y
ou to access information and to view and change var-
i
ous default settings. Follow the steps below to use the
maintenance mode.
Insert the key into the console.
See GETTING STARTED on page 14.
Hold down the ENTER AGE button and the
RESET button simultaneously for two seconds
to select the maintenance mode.
When the maintenance mode is selected, the
words MAINTENANCE MODE will appear in the
main display.
Press the ENTER AGE button to view the total
number of hours that the INCLINE TRAINER
has been used.
Press the ENTER AGE button again to view the
total distance that the walking belt has moved.
Note: Disregard the word MILES in the main dis-
play; the number in the main display is the total
number of kilometres.
Press the
ENTER AGE button again and set
the delay time for the timeout mode.
Any time that the INCLINE TRAINER is not used
for several minutes, the console will enter a time
-
out mode and the words PUSH ANY BUTTON TO
START A NEW PROGRAM will begin to scroll
across the main display. To set the number of min
-
utes before the console will enter the timeout
mode, press the + and – buttons beside the
E
NTER AGE button. The delay time can be from 1
to 15 minutes.
Press the ENTER AGE button again and set
the program time for the CARDIO WALK 1,
ENDURANCE 1, and FINISH LINE 1 programs.
The CARDIO WALK 1, ENDURANCE 1, and FIN-
ISH LINE 1 programs can be set to last for 20, 30,
or 40 minutes. To change the setting, press the +
and – buttons beside the ENTER AGE button.
Press the ENTER AGE button again and set the
program time for the CARDIO WALK 2,
ENDURANCE 2, and FINISH LINE 2 programs.
The CARDIO WALK 2, ENDURANCE 2, and FIN-
ISH LINE 2 programs can be set to last for 20, 30,
or 40 minutes. To change the setting, press the +
and – buttons beside the ENTER AGE button.
Press the ENTER AGE button again to check
for controller errors.
If there are no controller errors, the words NO
CONTROLLER ERRORS will appear in the main
display. If there is a controller error, the name of
the error will appear in the main display. If this oc-
curs, press the RESET button. If the same con-
troller error appears repeatedly, please contact
your distributor.
8
7
6
5
4
3
2
1