Filter
Top Products
53
Nautilus® TreadClimber®, Model TC916 Owner’s Manual
Software revision:
• Display the console software revision number. The console will display
“CONS ###-###”.
Machine type:
• Display the machine type the console is currently configured to. The console will display
“TREADCLIMBER” or other machine type.
Machine run time in hours since last cleared (used for maintenance):
• Display the machine run time since last cleared. The console will display “MAINT HOURS
#####”. This will provide the number of hours between service or maintenance calls. The
machine run time is reset to zero in the following Diagnostics section.
3. To exit “MACHINE STATUS”, press the [CLEAR] key.
Diagnostic Codes
Diagnostic codes are used to test various components of the machine such as the display,
keyboard, serial port, alternator, and tachometer, as well as viewing the error log information
and resetting the time between service or maintenance calls. To run diagnostics and view
diagnostic information:
1. Press [Speed: UP], [6], [ENTER]. The console will display “DIAGNOSTICS”
2. Press [Speed: UP] or [Speed: DOWN] to scan through the choices. Select the option you
want to view by pressing [ENTER].
The diagnostic options are as follows:
Test display:
• To test the LCD display, press [ENTER] when the message, “DISPLAY TEST” is displayed.
The console screen alternates turning on all LCD segments and a representative program
screen. Verify that all LCD segments turn on. Press [CLEAR] to exit.
Test keyboard:
• To test all the keys on the keyboard, press [ENTER] when the message, “KEY TEST” is
displayed. Then, press any key on the keyboard and that key’s name will be displayed in
the text line. Press [CLEAR] as the last key to exit this test.
Test serial port:
• To test the serial port, press [ENTER] when the message, “SERIAL TESTS” is displayed.
This test performs a serial loop back test. Select the CSAFE RS-232 selection. Select the
CSAFE -1 Loopback selection. Console will display either “PASS” or “FAIL”.
3. To exit “DIAGNOSTICS”, press the [CLEAR] key.
CONSOLE CODES