Filter
Top Products
11
Nautilus® TreadClimber®, Model TC916 Owner’s Manual
NAUTILUS
®
TREADCLIMBER
®
OPERATION
TreadClimber
®
Power Plug Receptacle
The Commercial Series TreadClimber
®
Model TC 916 has one power plug
receptacle located on the front side of the motor pan.
Turning on the Power
The TreadClimber
®
exercise machine can be turned on by moving the power
switch located at the front of the machine, to the ON
position.
Understanding the Display and
Controls
The TreadClimber
®
console display is a computerized panel used to operate
the TreadClimber
®
exercise machine and see all workout data and operational
status. You should familiarize yourself with the operation of the TreadClimber
®
machine and location of all keys before beginning use.
Limited Access Control/Magnetic Safety Stop
Limited-access control lets you restrict TreadClimber
®
machine use to
authorized personnel. It also lets you stop the TreadClimber
®
machine in an
emergency. The magnetically-activated control is located on the bottom of
the display as shown. The limited-access control is deactivated on machines
shipped from the factory.
Magnetic Safety Stop Activation
To activate the limited-access control and restrict access, place the magnetic
safety stop cord supplied with the TreadClimber
®
machine in the designated
area located below the display.
The magnet will activate the control. If you remove the key, the TreadClimber
®
treadle belts will stop and the controller will not respond to any key presses.
Accumulated values will remain on the display until you turn off the power, or
press [CLEAR].
The console will display a message, “REPLACE MAGNET” when you remove
the magnetic key from its designated area. You must replace the key or
deactivate the control to start the walk belts.
On/Off Switch
Magnetic Safety Stop
Power Plug