Filter
Top Products
3 - 21
new symbols as long as the trigger is pulled. When this programming selection
is turned Off, the imager will only read the symbol closest to the aiming beam.
Default = Off.
No Read
With No Read turned On, the imager notifies you if a code cannot be read. If
using a Quick*View Scan Data Window, an “NR” appears when a code cannot
be read. If No Read is turned Off, the “NR” will not appear.
Default = Off.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,”
you can edit the output message using the Data Formatter (page 5-5). The hex
code for the No Read symbol is 9C.
Print Weight
Print Weight is used to adjust the way the imager reads Matrix symbols. If an
imager will be seeing consistently heavily printed matrix symbols, then a print
weight of 6 may improve the reading performance. For consistently light print-
ing, a print weight of 2 may help. After scanning the Set Print Weight
bar code,
set the print weight (from 1-7) by scanning digits from the inside back cover,
then scanning Save.
Default = 4
.
On
* Off
On
* Off
Set Print Weight
* Default