Filter
Top Products
1 - 14
25 inches per second, Output Polarity to black high, and Idle State to high. (If
you want to change the terminal ID
only
, without changing any other imager set-
tings, refer to Terminal ID on page 2-1.)
Menu Bar Code Security Settings
Honeywell 2D imagers are programmed by scanning menu bar codes or by
sending serial commands to the imager. If you want to restrict the ability to
scan menu codes, you can use the Menu Bar Code Security settings. Contact
the nearest technical support office (see Technical Assistance on page 15-1)
for further information.
Wand Emulation
Plug & Play
Same Code
Wand Emulation
Plug & Play
(Code 39 Format)