Honeywell 4600g/4600r Home Gym User Manual


 
1 - 5
Connecting the Imager with USB
Note: See "Imager Models" on page 1-2 to determine which interfaces apply to
your imager.
An imager can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the imager first, then to the com-
puter.
2. Program the imager for a USB interface using the Plug and Play bar codes
beginning on page 1-9.
3. The imager beeps.
4. Verify the imager operation by scanning a bar code from the Sample
Symbols in the back of this manual.
For additional USB programming and technical information, refer to “USB Appli-
cation Note,” available at
www.honeywellaidc.com.