Filter
Top Products
9
9. Orient the Right Weight Guides (42) with the
ellipse holes on top. Slide the Weight Guides into
the bracket on the Short Base (2). Attach the
Guides to the Base with an M10 x 155mm Bolt
(95), two 19mm Spacers (86), two M10 Washers
(91), and an M10 Nylon Locknut (87).
Slide two Weight Bumpers (49) onto the Right
Weight Guides (42). Slide eleven Weights (44)
onto the Guides. Make sure the slots for the
Weight Pin (not shown) are on the indicated
side and on the bottom of the Weight.
Press a Weight Tube Bumper (48) into the Long
Weight Tube (43). Insert the Tube into the stack
of Weights (44) as shown.
Lubricate the indicated holes in a Top Weight (45)
with grease. Slide the Top Weight onto the Right
Weight Guides (42). Make sure the groove for
the pin on the Long Weight Tube (43) is on the
bottom.
Attach the Right Weight Guides (42) to the
Butterfly Top Frame (7) with an M10 x 155mm
Bolt (95), two M10 Washers (91), and an M10
Nylon Locknut (87). Do not tighten the
Locknuts yet.
9
Slot
Lubricate
Pin
Ellipse
Holes
42
7
42
43
95
2
48
45
87
91
91
49
49
86
44
8. Press three 50mm x 75mm Inner Caps (58) into
the Butterfly Top Frame (7).
Attach the Butterfly Top Frame (7) to the Butterfly
Upright (3) with two M10 x 95mm Bolts (92), two
M10 Washers (91), and two M10 Nylon Locknuts
(87). Do not tighten the Locknuts yet.
Attach the Butterfly Top Frame (7) to the Top
Frame (6) with an M10 x 70mm Bolt (134), an
M10 Washer (91), and an M10 Nylon Locknut
(87). Do not tighten the Locknut yet. Make
sure the Bolt is inserted through the indicated
hole in the Top Frame; a bolt will be inserted
through the other in a later step.
8
58
87
87
87
134
58
92
91
91
91
58
3
7
87
95
91
91