Filter
Top Products
12
16. Press two 40mm x 50mm Inner Caps (21) into
the Dip Assist Arm (128). Attach a Knee Rest
Bumper (123) to the Dip Assist Arm with an M4 x
20mm Self-tapping Screw (14).
Attach the Dip Assist Arm (128) to the Dip Assist
Frame (127) with two M10 x 65mm Bolts (18) and
two M10 Nylon Locknuts (87). Do not overtight-
en the Locknuts; the Dip Assist Arm must be
able to pivot easily.
Insert the Dip Pin (135) into the Dip Assist Arm
(128), and rotate the Pin so that it is wrapped
over the Dip Assist Arm.
Attach the tether on the Dip Pin (135) to the Dip
Assist Frame (127) with an M4 x 20mm Self-tap-
ping Screw (14).
18. Press a 40mm x 50mm Inner Cap (21) into the
Right Butterfly Arm (26). Wet the lower end of the
Arm with soapy water. Slide a Long Pad (54) onto
the Arm.
Attach a Press Handle (27) to the Right Butterfly
Arm (26) with two M8 x 20mm Button Head
Screws (51). Slide the Long Pad (54) down so that
the bottom is flush with the lower end of the Arm.
Press a 25mm Round Inner Cap (29) into the
Press Handle (27). Wet the Press Handle with
soapy water. Slide a Long Handgrip (28) onto it.
Repeat this step with the Left Butterfly Arm
(25).
17. Press a 38mm Square Inner Cap (67) into the
Butterfly Upright Extension (126). Attach the
Extension to the Butterfly Upright (3) with two
M10 x 95mm Bolts (92), two M10 Washers (91),
and two M10 Nylon Locknuts (87). Make sure
the decals on the Extension are right-side up.
Press a 50mm x 70mm Inner Cap (125) into the
Butterfly Frame (47).
Lubricate an M10 x 75mm Bolt (101) with grease.
Attach the Butterfly Frame (47) to the Butterfly Top
Frame (7) with the Bolt and an M10 Nylon Locknut
(87). Do not overtighten the Locknut; the
Butterfly Frame must be able to pivot easily.
16
21
18
18
87
127
128
123
14
21
17
18
14
125
87
3
7
67
91
91
87
92
47
92
25
26
51
54
51
21
29
27
28
135
126
101