Filter
Top Products
ENG-26
Sports mode
Lower display data
(Switch using the MODE2 button)
Displays additional ride data.
*1 The training function screen displays one of the following; countdown distance,
countdown time, or interval. For details, see “Training function (countdown func-
tion and interval function)” on page 32.
*2
When measurement is stopped in the training function screen, shortcut operation (press and hold
the MODE2 button for 3 sec.) moves to the Setup mode “Setting the training function” (page 36).
Starting/Stopping measurement
”km/h [mph]” or “m [ft]” icon flashes during speed measurement.
Initially, the auto-mode function which starts or stops measure-
ment automatically in sync with the bicycle motion is ON. Auto
measurement is switched to manual measurement and vice
versa by ON/OFF operation in the auto-mode. For details, see the
Setup mode “Setting the auto-mode” (page 58). The maximum
speed, maximum heart rate, and maximum cadence are updated
regardless of starting/stopping the measurement.
To use this unit as a heart rate monitor, start/stop the measure-*
ment using the SSS button in the manual measurement.
When the auto-mode is on, you cannot start the measurement.
Auto-mode (automatic measurement)
When the auto-mode is on, appears on the screen. The wristwatch detects the
wheel spinning, and starts/stops the measurement automatically.
When the transmission is stopped and Sensor signal icons * and are off, the
measurement will not start even after the bicycle starts. If a bicycle is stopped for
more than 5 minutes or if heart rate sensor is either far from the bicycle or off the
body, it will go into sleep. This normally happens when taking a rest during the ride.
To recover from the transmission sleep, press the MODE1 or MODE2 button to turn
on the sensor signal icons. For details, see “Transmission sleep mode” on page 23.
AT icon
Switch pressing the MODE2 button
Elapsed time
Clock
Trip distance
Calorie Consumption
Training function
*1
Lap timer
MODE2
MODE2
MODE2
MODE2
MODE2
MODE2
MODE2
Shortcut
*2
(press & hold for 3 sec)
To the setting count-down screen
in Option mode (page 36)
When the
measurement is
stopped