Filter
Top Products
ENG-21
Before use
Continue
Formatting/Restarting operation
There are 2 different wristwatch set-up operations; formatting and restarting operations.
Follow the appropriate one depending on the situation.
Formatting :
When you want to delete all data and the setup of the wristwatch.
Restarting : When you use the unit for the first time after purchasing, or after replac-
ing batteries, or an error is displayed.
In the restarting operation, the following data are retained.*
SPORTS MENU Date
OPTION MENU Setting the target zone
DATA MENU
•Savedledata
•Ridedata
•Logdata
SETUP MENU
•Alarmclocksetting
•Tirecircumferenceand
Sensor currently selected
•SensorID
•Measurementunit
•Recordinterval
•Auto-mode
•Trainingfunction
•Soundsetting
•Sealevelaltitude
Flows of the formatting and restarting operations
The formatting and restarting procedures are as follows.
In the case of the formatting operation, you can set the “tire circumference” *
and “measurement unit” sequentially after you set the “clock/date”. Each
set-up procedure is described on the page referenced.
After you complete the set-up, be sure to synchronize the sensor ID according
to the Setup mode “Searching for sensor ID” (page 53).
For restarting:
The date when last executed the restarting *
operation will be initially displayed.
Restarting operation (page 14)
Setting the clock/date (page 15)
Clock mode
For formatting:
Formatting operation (page 14)
Setting the clock/date (page 15)
Selecting measurement unit (page 18)
Tire circumference input (page 16)