Filter
Top Products
B 38 C 39
Time of Day
Heart rate measure mode
Exercise recording mode
You can use two modes while
exercising: Measure or Exercise mode.
In the Measure mode you can see
your heart rate but exercise
information will not be recorded. In
the Exercise mode your exercise is
recorded. Stopwatch and other
calculations are also started.
1. Wear the transmitter and the wrist receiver as described in “Easy start” section.
2. To ensure that the code search will find a signal:
• Keep the wrist receiver within 3 feet/ 1 meter of your transmitter.
• Check that you are not near: people with heart rate monitors, high
voltage power lines, televisions, mobile phones, cars, motor driven
exercise equipment or other electromagnetic disturbance.
Heart Rate Measure Mode
C. EXERCISE
Swap Time 1 or Time 2
In the Time of Day display press and hold the down button. Time 1 or
Time 2 is displayed in the uppermost row for a couple of seconds. Displayed
time will now be used in all watch and alarm functions. If you chose time 2,
“2” is displayed in the Time of Day display.
Shortcut to Watch Setting Loop
Press and hold the signal/light button for a few seconds to enter into the
watch setting loop. If you want to skip some parts and go directly to a watch
function, scroll up or down button until the desired watch function is
displayed. Set the function as in the “Watch settings” section.
Swap Measuring Units
As you set your user information for weight and height, press and hold the
signal/light button until the units are swapped. Release the button.
Swap Date, User ID Number, User Name and Logo
You are able to set a user ID number, user name and logo with the Polar
Precision Performance software. These settings are shown on the upper row
of the Time of Day display. You can swap between the user ID, user name,
logo and date by pressing and holding the up button.
You can upload 7 reminders, each including time and name, to your wrist
receiver from Polar Precision Performance software.
The reminder sounds an alarm only when time of day is displayed. When
the reminder alarm comes on, it will sound for 15 seconds. You can turn it
off by pressing any of the buttons except the signal/light button.
Erase the reminder text by pressing any of the buttons except the
signal/light button.
To continue your settings, press the stop button or to return to the Time of
Day display, press and hold the stop button.
Setting Tips
S810i manual USA GBR A.pm6 29.7.2002, 14:1438-39