Filter
Top Products
1. In Diagnostics menu, select “MAINTENANCE” and accept it by pressing the JustGo
TM
/ENTER key. There are two sub
menu items: AVERAGE and RESET. Scroll between them with the INCREASE/DECREASE key and press the JustGo
TM
/ENTER
key to accept your choice.
2. If you want to see the average current drawn by the motor simply go into the AVERAGE menu that will display the
average current in the motor from the last time it has been reset. To get out of that menu simply press CLEAR/STOP key.
3. If you have done the maintenance, you need to reset the maintenance counter by accessing the RESET MAINTENANCE
menu and enter that menu and confirm that it has been done. You will then get a message that the “MAINTENANCE
COUNTER HAS BEEN RESET”.
4. Press the CLEAR/STOP key to terminate the test.
Level of alerts America International
Diamond sign 13.5 amps 10 amps
Square sign 14.5 amps 10.8 amps
General Care
Your T360–T560 have been designed and built to give you trouble free use. For maximum safety however, you should
periodically check your unit for signs of wear.
Here’s a quick check list followed by reference Table 3:
• After each workout, you should wipe down your T360–T560 using a mild, non-abrasive liquid cleanser applied on a soft
cotton cloth. Do not spray cleansers directly on the unit or use an excessively damp cloth. Do not clean the unit with the
power ON, be sure that it is OFF.
• Be sure that the treadmill is on a level surface and that it is not rocking. Excessive rocking may cause the running belt to
track to one side of the deck resulting in accelerated wear of the running belt.
• Keep liquids including excessive sweat away from the computer console.
• The running belt and deck surface should be kept clean. Dirt and other debris can cause slipping when exercising.
• Check that each handle bar is secure on the frame.
• Do not put any lubricating product other than the Bodyguard
®
lubricant.
• Place a carpet or rubber mat under the treadmill to avoid any build up of debris from your exercise shoes. Under
extreme conditions, some debris may collect on the floor just behind the rear roller. It is also recommended to periodically
remove any dust that may have accumulated under the treadmill. Excessive amounts of dust may enter into the motor
assembly and cause the motor to overheat.
• It is very important to periodically remove any dust that may have accumulated under the motor cover. Use compressed
air to blow out the accumulated dust in the motor and board area.
WARNING – To prevent electrical shock or risk of fire, always turn the power OFF and disconnect the power cord whenever
you are inspecting and repairing your T360–T560.
Belt and Running Deck
Running Belt
The running belt supplied with each treadmill is of the highest quality, offering superior traction and low noise under
extreme conditions. It is therefore important to maintain each running belt periodically by observing that no cuts have
appeared over time, and that the running belt has not shifted to one side of the deck surface. If the running belt constantly
tracks (or moves) to one side of the deck, you must adjust the alignment bolts placed at the rear of the running belt.
See Belt Alignment for complete procedure.
29
MMaaiinntteennaannccee IInnffoorrmmaattiioonn
6
Maintenance Information