TL-WR710N 150Mbps Wireless N Mini Pocket Router
- 8 -
)
Note:
It is recommended that you connect a PC/notebook to the LAN port of the Router with an Ethernet
cable, and then login the Router from the PC/notebook to set the Router in Repeater mode.
2.3.4 Client Mode
TL-WR710N is used as a wireless network card to connect the wireless network signal or wireless
router.
On this mode, the wired port LAN/WAN works as LAN. Computer could connect to the device by
either wired or wireless way.
Figure 2-4 Hardware Installation of the TL-WR710N in Client Mode
1. Connect the PC to the LAN or LAN/WAN port of TL-WR710N router with an Ethernet cable.
2. Plug the power plug of TL-WR710N in electrical wall socket.
3. Power on the PC(s).
2.3.5 WISP Client Router Mode
In WISP mode, TL-WR710N enables multiple users to share Internet connection from WISP.
On this mode, the LAN port devices share the same IP from WISP through Wireless port. While
connecting to WISP, the Wireless port works as a WAN port at WISP Client Router mode. The
Ethernet port acts as a LAN port.
