When the Indicators Provide No Help
42
Condition
The remote control does not work
Probable cause Remedy
Is the remote control light-emitting area
facing towards the remote control light-
receiving area when it is operated?
The operating angle for the remote control is
approximately ±30º horizontally and approximately
±15º vertically. Use the remote control within these
ranges. (See Quick Setup poster)
Is the remote control too far from the
projector?
The operating distance for the remote control is
approximately 6 m (20 ft.). Use the remote control
within this distance. (See Quick Setup poster)
Is direct sunlight or strong light from
fluorescent lamps shining onto the remote
control light-receiving area?
Avoid using the projector in places where the remote
control light-receiving area is exposed to
strong light.
Has the battery insulating tape been
removed?
When using the remote control for the first time,
pull out the insulating tape that
is protruding from
the battery holder.
(See Quick Setup poster)
Is the battery inserted?
Insert the battery. (p.47)
Is the battery depleted?
Replace the battery with a new one. (p.47)
Is the battery inserted incorrectly?
Reinsert the battery so it is installed correctly. (p.47)
Condition
The power does not turn off (after the [Power] button
is pressed)
Probable cause Remedy
The Power indicator remains orange.
This projector is designed so that the Power
indicator remains lit even after the power has been
turned off.
The Power indicator will switch off when the power
cord is disconnected from the electrical outlet.
The cooling fan does not stop.
After you press the [Power] button to turn off the
power, the cool-down
period starts.
After the cool-down
period,
the Power indicator
changes to a steady orange, and you can then
disconnect the power cord from the electrical outlet.
* The cool-down period lasts for about 25 seconds.
The actual time will vary depending on the
external air temperature.
S-Video/VideoComputer
Menu
A/V Mute
E-Zoom
Freeze
Color Mode
Power
ESCAuto
Enter
