19
Basic Operations
If flickering, fuzziness or interference appear in images that are input from
the computer, and this cannot be fixed using automatic setup, adjust the
sync
manually using the following procedure.
Procedure
1
Press the [Menu] button on the remote
control, and then select Sync from the
Video menu.
For details on this operation, refer to “Using the
Configuration Menus.” (p.29)
2
Press the [ ] and [ ] buttons to set the
sync value.
The sync value increases or decreases each time a
button is pressed.
3
After making the adjustment, press the [Menu] button to exit the configuration
menu.
Adjusting the Sync
•
If you adjust the sync without adjusting the tracking first, it will not be possible to get the best
adjustment results. Incorrect tracking adjustment may not be noticeable with some types of
picture. However, pictures with lots of lines and shading will tend to show incorrect tracking
adjustments more clearly, so be sure to check the tracking adjustment first.
•
It may also be possible to fix flickering and fuzziness by adjusting the brightness, contrast ,
sharpness and keystone correction settings.
+
-
+
-
+
-
Input Signal
Color Mode Select
Video
Audio
Setting
Advanced
About
Position
Adjust
Tracking
0
Sync . 0
Brightness 0
Contrast
Sharpness 0
RGB
YUV( YCbCr YPbPr)
Auto Setup
Reset
Execute
: Select: Return
Reset All
0
ON OFF
:
:
:
:
:
:
:
[Normal ]
: Adjust
EPSON Cinema Filter :
ON OFF
+
-
+
-
+
-
Input Signal
Color Mode Select
Video
Audio
Setting
Advanced
About
Position
Adjust
Tracking
0
Sync . 10
Brightness 0
Contrast
Sharpness 0
RGB
YUV( YCbCr YPbPr)
Auto Setup
Reset
Execute
: Select: Return
Reset All
0
ON OFF
:
:
:
:
:
:
:
[Normal ]
: Adjust
EPSON Cinema Filter :
ON OFF
