When Having Trouble
36
: lit : flashing
High-speed
cooling in
progress
(This is not an abnormality, but if the temperature rises too
high again, projection will stop automatically.)
•
Set the projector up in a place which is well-ventilated,
and make sure the air filter and exhaust vents are clear.
•
Clean the air filter.
p.46
Power Indicator
Status Cause Remedy or Status See Page
Standby status (Not abnormal)
The power cord should only be disconnected when the
projector is in this condition.
Press the [Power] button to start projection.
p.8
Cool-down in
progress
(Not abnormal)
•
Please wait.
The cool-down
period lasts for about 25 seconds.
•
The [Power] button does not work during cool-down.
Press the button again after cool-down ends.
p.10
Projection in
progress
(Not abnormal) p.9
Warm-up in
progress
(Not abnormal)
Please wait.
Warm-up time is approximately 40 seconds.
After warm-up is complete, the flashing green indicator
changes to steady green.
p.9
•
If the projector is not operating properly even though the indicators are all showing normal
status, refer to “When the Indicators Provide No Help” on the following page.
•
If an indicator is showing a status that does not appear in the previous tables, contact your
dealer or the nearest address provided in the International Warranty Terms brochure that came
with the projector.
Status Cause Remedy or Status See Page
Orange
Orange
Orange
Green
Green
