5-8 CHAPTER 5: INSTALLING NETWORK DRIVERS
The following sample PROTOCOL.INI file uses NetBEUI (2.0)
as the NDIS transport protocol with 3Com drivers.
[PROTOCOL MANAGER]
DRIVERNAME = PROTMAN$
[NETBEUI_XIF]
DRIVERNAME = NETBEUI$
BINDINGS = TLPC3_NIF
[TLPC3_NIF]
DRIVERNAME = TLPC3$
3 Edit the PROTOCOL.INI file and include the text from the
PROTOCOL.PCM file after the DRIVERNAME=TLPC3$
statement.
■ If you are not using Card Services, the statements should
look similar to the following:
DRIVERNAME = TLPC3$
PRIMARY
INTERRUPT = 3
MMIO = 0XCC00
RAM = 0XD000
RAMSIZE = 16
RINGSPEED = 16
■ If you are using Card Services, the statements should look
similar to the following:
DRIVERNAME = TLPC3$
RINGSPEED = 16
4 If you have not already done so, copy the 3Com DOS NDIS
driver (TLPC3.DOS) into the LANMAN subdirectory.
The NDIS driver is located in the \NDIS\DOS subdirectory on
the TokenDisk diskette.
5 Add the following lines to your CONFIG.SYS file (located
in the root directory of your boot disk):
DEVICE = C:\LANMAN\PROTMAN.DOS/I:C:\LANMAN
DEVICE = C:\LANMAN\TLPC3.DOS
DEVICE = C:\LANMAN\<PROTOCOLDRIVER>.DOS
If you are using DOS 6.0, you must use the Microsoft Protocol
Manager version 2.0 and not the 3Com Protocol Manager.
