3-4 CHAPTER 3: USING THE AUTOLINK FEATURE FOR NETWARE
This completes the procedure for avoiding conflicts with a
memory manager. You are now ready to run the AutoLink
program.
Using the AutoLink Feature
Follow these steps to use the AutoLink feature:
1 Place the TokenDisk diskette in a floppy drive on your
computer and make that drive the active drive. For
example, type:
A: [Enter]
2 Type at the prompt:
INSTALL [Enter]
The first time you use the TokenDisk diskette, the 3Com
license appears.
3 To accept the terms and conditions of the 3Com end-user
software license agreement, type Y.
A status message appears, followed by a prompt asking for
the ring speed.
4 Type the correct ring speed (16 or 4) and press [Enter].
A message appears, stating that the AutoLink program has
completed the configuration.
5 Remove the TokenDisk diskette and reboot your computer.
The login prompt for a NetWare server appears.
6 Log in to the NetWare server using your user ID and
password provided by your network administrator.
The 3C689 adapter is now a NetWare DOS ODI client.
Installation and configuration are complete. If you have
problems, see Chapter 6, “Troubleshooting,” for help.
