Filter
Top Products
2.
3,
4.
Insert two M10 x 65mm Carriage Bolts (103) up
through the Base (1). Place a piece of tape over
the Bolt heads to hold them in place. Connect
the Upright Base (2) to the Base with the two
Carriage Bolts and two M10 Nylon Locknuts
(!12). Do not tighten these Locknuts yet.
Connect the Upright Base (2) to the Base (1) with
two M10 x 67mm Bolts (111) and two M10 Nylon
Locknuts (112). Fully tighten these Locknuts.
Set the Mech Frame (!24) onto the Base (1)
behind the Upright Base. Handtighten two M10 x
73mm Screws (137) and two M10 Washers (129)
into the indicated holes in the Base and Mech
Frame, Note: The Mech Frame will not be
shown in the following drawings for clarity.
Note: One end of the Rope (70) is connected
to the Right Arm Frame (17t). Untie the loose
end of the Rope and route it through the Upright
Base (2). Make sure the loose end of the Rope
is still between the 90ram Thin Pulley (88) and
Cable Trap (78) (see the inset drawing), and
that it crosses under the connected end of the
Rope.
Insert two M14 x 155mm Bolts (107) through the
Right Arm Frame (171) and the Upright Base (2).
Hand tighten two M!4 Nylon Locknuts (!27) onto
the Bolts,
Route the loose end of the Rope (70) through the
Left Arm Frame (8) and a Swivel Arm (29). Make
sure the Rope is under the indicated rod in the
Swivel Arm.
Attach the Swivel Arm (29) to the Left Arm Frame
(8) with an M4 x 5mm Self-tapping Screw (!76).
Attach a "V"-pulley (93) inside the Swivel Arm
(29) with an M10 x 53mm Button Bolt (140) and
an M10 Nylon Locknut (112),
Route the loose end of the Rope (70) through a
Rope Cover (169) and a Link (167) as shown.
Make sure the large hole in the Rope Cover is
on the side shown. Secure the set of Rope
Clamps (165, 166) on the Rope with two M5 x
16mm Button Screws (164), Make sure that
Rope is in the grooves of the Rope Clamps,
that there is t/2" between the Link and the
Rope Clamps, and that the two Screws are fully
tightened. Slide the Rope Cover over the Rope
Clamps,
f"--. ,1/07 2\/4.,_ 4/ _ /
_27
___ 137
129
78 88
---T--T_
- _--o Z_ 93"
4
164
70 169 _i
Hole 166 67
7