Filter
Top Products
17. Press the Front Leg Foot (38) onto the Front Leg
(4). Note: The front of the Front Leg Foot is
taller than the back of the Foot.
Attach the Front Leg (4) to the Rail (5) with four
M8 x 20mm Screws (95) and four M8 Washers
(152).
18. Pull out the Seat Knob (138) as far as it will go,
and set the Seat Carriage (!6) on the Bench Rail
(5).
Loosely attach two 8mm Spacers (123), a 59mm
Spacer (122), and two Seat Wheels (74) to the
bottom holes in the Seat Carriage (16) with an
M8 Nylon Jamnut (139) and an M8 x 102mm Bolt
(119). Make sure the parts are oriented as
shown in the inset drawing.
19. Make sure that the wide sides of all six Seat
Wheels (74) are pressed against the Rail (5).
While a second person presses down on the Seat
(25), hold the bottom Seat Wheels firmly against
the bottom of the Rail and properly tighten the
indicated M8 Nylon Jamnut (139).
Engage the Seat Knob (138) into an adjustment
hole in the Rail (5).
17
18
95 95
152
Front is
taller _38
119
123
Side
19
74-
25
5-
74 74 139 138
123
12