Filter
Top Products
10. Insert an M1O x 125mm Button Screw (144)
through an M!O Washer (!29), the Upright (3),
and the Backing Plate (not shown). Bold the Bolt
in place by sticking a piece of tape over the
bolt head.
Tighten the two Mt0 Nylon Locknuts (1t2)
used in step 6. Tighten the two Mt0 x 20ram
Screws (tt3) and two Mt0 x 25ram Screws
(t05) used in step 9.
Attach the Mech Frame (124) to the Base (1) with
two M10 x 73ram Bolts (137) and two M1O
Washers (129), Do not tighten the Bolts yet.
Attach the Mech Frame (124) to the Upright (3)
with the M10 x 125mm Button Screw (144). Make
sure the Upright and Mech Frame are properly
aligned before tighten the Screw.
Tighten the four M10 x 73ram Bolts (137) in
the Base (1) and the two Mt0 Nylon Locknuts
(tt2) used in the first paragraph of step 2.
Snap the Side Mech Cover (81) into place on the
Mech Covers (14 and 15).
11. Wet a Squat Arm (18) and the inside of a Small
Foam Pad (36) with soapy water. Slide the Foam
Pad onto the Squat Arm.
Grease an M10 x 73mm Bolt (137). Attach a
Squat Arm (18) to the Squat Carriage (!0) with
the Bolt, two 24mm Plastic Washers (110), and
an M1O Nylon Locknut (112). Do not overtighten
the Locknut; the Squat Arm should be able to
pivot with intermediate effort.
Repeat this step with the other Squat Arm
(18).
12. Orient the Top Frame (20) with the mark in the
position shown. Attach the Top Frame to the
Upright (3) with two M10 x 65mm Button Screws
(!17) and two M10 Washers (129). Press the
Plastic Cap (46) into the Upright, over the Top
Frame.
lO
11
12
129
144
124
81
137
Grease_
18
112
20
Mark
3
117 129
46
).
"1 129_
137
18
10