Filter
Top Products
20. Attach the Leg Lever (13) to the Front Leg (4) 20
with a Leg Lever Pin (91) and a Cotter Pin (90).
21. Route the short end of the Split Cable (72)
through the Front Leg (4) and attach it inside the
Leg Lever (13) with a Leg Lever Pin (91) and a
Cotter Pin (90).
Attach a 90mm Pulley (92) inside the Front Leg
(4), over the Spit Cable (72), with an M10 x
92mm Bolt (116), two M10 Washers (129), two
25mm Spacers (130), and an M10 Nylon Locknut
(112).
22. Insert the two Short Pad Tubes (32) into the Leg
Lever (13). Slide two Large Foam Pads (37) onto
each Short Pad Tube.
Repeat this step with the Long Pad Tube (153)
and the Front Leg (4).
21
22
91
72
91
112
129_ _ 130
4
37
13