Filter
Top Products
GB
7
OWNER'S MANUAL
•
C6
with the elastic belt, fi rmly enough so that the
electrodes remain in contact with the skin while
pedaling, but not so tight that normal breathing
is prevented. If you wear the transmitter and belt
over a light shirt, moisten the shirt slightly at the
points where the electrodes touch the shirt. The
transmitter automatically transmits the heart-rate
reading to the meter up to a distance of about
1 meter. The heart-rate value is displayed in the
meter. Follow your heart rate during the training.
REMARKS ON TELEMETRIC
MEASUREMENT
If the electrode surfaces are not moist, the heart
rate reading will not appear on the display. If the
electrodes are dry, they must be moistened again.
Allow the electrodes to warm up properly to ensure
accurate heart-rate measurement. If there are
several telemetric heart rate measurement devices
next to each other, the distance between them
should be at least
1.5 m. Similarly, if there is only
one receiver and several transmitters in use, only
one person with a transmitter should be within
transmission range. The transmitter is switched
to an active state only when it is being used for
measurement. Sweat and other moisture can,
however, keep the transmitter in an active state and
waste battery energy. Therefore it is important to
dry the electrodes carefully after use.
When selecting training attire, please note
that some fi bers used in clothes (e.g. polyester,
polyamide) create static electricity which may
prevent reliable heart rate measurement.
Please note that a mobile phone, television and
other electrical appliances form an electro-magnetic
fi eld around them which will cause problems in
heart rate measurement.
ERROR CODES
The user interface will display information about
operational faults. An error code begins with the
abbreviation Err.
ERR 1 Speed sensor problem
ERR 2 Data communication problem
Remove the power cord from the power outlet,
wait for 1 minute and then restart. If the error
message does not disappear, please contact your
Tunturi dealer.
MAINTENANCE
The equipment requires very little maintenance.
Check, however, from time to time that all screws
and nuts are tight. Clean the equipment with a
damp cloth. Do not use solvents.
NOTE! Never remove the protective covers.
NOTE! The brake forms a magnetic fi eld which
may damage the mechanism of a watch or the
magnetic identifi cation tape of a credit or cash
card if they come into immediate contact with the
magnets. Never attempt to detach or remove the
magnet of the magnetic brake.
If you notice a malfunction during use, contact the
dealer. Always give the model and serial number
of your device, please state also the nature of the
problem conditions of use and purchase date. In
spite of continuous quality control, individual
defects and malfunctions may occur in individual
components. It is in most cases unnecessary to
take the whole equipment for repair, as it is usually
suffi cient to replace the defective part.
TRANSPORT AND STORAGE
The device is easy to move by pushing along on the
integrated transport wheels. Tilt the device from
the front and push along the fl oor on the wheels at
the front support.
To prevent malfunctioning of the equipment, store
in a dry place with as little temperature variation as
possible, protected from dust.
DIMENSIONS
Length......................... 130cm
Width ......................... 61 cm
Height......................... 156 cm
Weight ........................ 73 kg
All Tunturi models are designed to meet the
electromagnetic compatibility directive, EMC and
are affi xed with the CE conformity marking. User
safety of Tunturi products is tested, and are affi xed
with the TÜV-marking.
NOTE! The instructions must be followed carefully
in the assembly, use and maintenance of your
equipment. The warranty does not cover damage
due to negligence of the assembly, adjustment
and maintenance instructions described herein.
Changes or modifi cations not expressly approved
by Tunturi Oy Ltd will void the user’s authority to
operate the equipment!
Due to our continuous policy of product
development we reserve the right to change
specifi cations without notice.
Tunturi_c6_ohjekirja 7 3.10.2003, 14:26:57