GB
3
OWNER'S MANUAL
•
C6
FRONT FRAME TUBE
Remove the rubber band from around meter cable
coming from the frame tube. Attach the meter
cable to the connector coming from the front
frame tube. Push the front frame tube inside the
frame tube: do not damage the meter cable! Attach
the front frame tube tight to the frame with the
washers and attachment screws.
ARMS
Push the metal shaft through the bracket housing
of the left arm. Attach now the left arm to the
front frame tube by pushing the metal shaft
through the opening in the tube. Push the right
arm on the shaft and lock it by tightening a large
washer, a locking sleeve and a screw to the both
ends of the shaft. Tighten the arms using two Allen
keys. Push the left footrest support forward so that
you can push the adjustment tube in the front of
the foot rest support inside the arm tube. Lock the
adjustment tube with the locking screw. Repeat the
procedure with the right footrest support.
NOTE! The European model allows selecting
adjustment (see Adjusting the footrest supports).
FOOTRESTS
Attach the footrests to the position of your choice
on the pedal shafts with two screws, two washers /
screw and locking nuts.
METER
Remove the two attachment screws at the back of
the meter. You can select the unit of weight to be
displayed by the switch at the back of the meter
housing. You can select either kg or LB (default =
kg). Attach the cable coming from the front frame
tube to the connector of the meter and push the
meter into place on top of the front frame tube.
Attach the meter with the two attachment screws.
HANDLEBAR
Fasten the handlebar fi rmly to the front frame tube
with two screws and two sleeves / screw. Slide the
plastic cover over the fastening screws.
POWER CORD
Plug the transformer into the connector, just above
the rear support, and then the transformer cord
into the wall socket.
•
Always unplug the appliance from the wall
socket and remove the cord from the appliance
immediately after use.
•
Make sure that the cord does not run
underneath the appliance.
Tunturi_c6_ohjekirja 3 3.10.2003, 14:26:55